MitsubishisystemSpindle outlet setting steps

When configuring the main shaft water outlet function of the Mitsubishi system, you need to enter the parameter setting interface of the system. In this interface, find the parameter number related to spindle cooling. Usually this number will be described in detail in the system manual. Next, adjust the parameter values according to actual needs, and turn on or off the function of the spindle outlet.

After completing the parameter setting, you need to save the operation to ensure that the setting takes effect. Then, check the status of the spindle outlet water through the system diagnostic function to confirm whether the settings are correct. If you find that the settings fail to achieve the desired effect, you should return to the parameter setting interface to recheck the setting values and ensure that all settings meet the requirements of the equipment's operation manual.

In the actual operation process, care should also be taken to keep the working environment clean to avoid the problem of poor coolant supply caused by clogging of foreign objects. At the same time, regularly check the pipeline connections of the cooling system to ensure that no leakage occurs, which is essential to maintain the good operating condition of the spindle.

Troubleshooting skills of Mitsubishi system spindle water outlet

When troubleshooting the water outlet of the main shaft of the Mitsubishi system, it is necessary to ensure that the coolant supply is normal. Check whether the coolant pump is working normally and whether the pipeline is clogged or leaking. If there is no problem with the coolant supply, then check whether the spindle outlet is clogged. You can use compressed air or special cleaning tools to clean up.

If the water outlet is unblocked, check the inside of the spindle for wear or damage. You can use an endoscope or disassembly for inspection. If wear or damage is found, the corresponding parts need to be replaced.

Also check whether the spindle outlet temperature sensor is working normally. If the sensor fails, it may cause abnormal water discharge. You can use a multimeter to measure the resistance of the sensor to determine whether it needs to be replaced.

Check whether the Mitsubishi system parameter settings are correct. Improper setting of some parameters may cause abnormal water discharge from the spindle. You can refer to the Mitsubishi system manual to check and adjust the relevant parameters.