hydraulic system、Central effluent filtration system、High pressure flushing equipment manufacturer

dmg Siemens system machining center does not discharge water: fault diagnosis and solution

The reasons for the non-exportation of water from DMG Siemens system machining centers may involve multiple aspects. Check whether the water pump is working normally. Water pump failure or power supply problems may cause the water supply to be unavailable. Check whether there is blockage in the waterway system, especially in the filter and nozzle parts. The accumulation of impurities may hinder the flow of water. Check whether the water pressure reaches the set value. Insufficient water pressure can also cause abnormal water discharge. If the above problems are eliminated, it may be a signal transmission problem of the control system, and the status of the PLC or related sensors needs to be checked. Ensure that the concentration and level of the coolant meet the requirements. Too low or too high concentration may affect the normal operation of the cooling system.